Search
< class="node node-sbcmag-page">
< class="col-sm-12 ">
>
>
* moving average applied to smooth out the data
Article
2012 August
Remembering the life and times of Bill McAlpine.
Article
2012 August
Take raw ore, throw it into the fires of hell & out comes steel.
Article
2012 August
- The inaugural Lumber Summit held May 14-15 in Charlotte, NC, brought together key lumber industry leaders, the top five lumber producers in North America, and component manufacturers representing approximately 700 million board feet of U.S. structural lumber purchases.
- The SBCA Lumber Collaboration Council (LCC) resulted from the success of the summit.
- A recent industry plant tour furthered relationships with the fire service and is a strong reminder to embrace plant tours as our most effective outreach tool.
Article
2012 August
- The exception to IRC Section R602.3.2 allows for the use of a single top plate in a wood stud wall if the design meets specific requirements.
- By cutting the volume of lumber in the top plate in half, a single top plate allows more space for insulation and can reduce thermal bridging through the lumber, which increases the thermal efficiency of the wall system.
- When trusses are centered over the studs with a tolerance of not more than 1", the stud spacing can be increased to 24" o.c., which removes more lumber, improves energy efficiency and still provides a continuous load path.
- To determine if the use of a single top plate is beneficial, a number of factors must be weighed.
Article
2012 August
The modern truss was invented in the 1900s, but using triangles in construction has been a common practice for ages. While on vacation, a member of SBC staff stumbled upon this interesting truss-like ceiling at the Duomo di Pistoia or Cattedrale di San Zeno in Pistoia, Italy. This ornately decorated portion of the roof spans a large section of pews running from an entrance up to an altar.