Products

Fire Damage Assessment

Question: 

How do you evaluate whether a metal plate connected truss is still usable after exposure to fire? Are there any recommended tests?

Locating A Truss Hauler In Nc

Question: 

I am looking for a company that can properly transport wood roof trusses on a one-time basis that are too large to fit into a box trailer. Trusses are to be fabricated in NC. Do you have any recommendations? Could be a specialty hauler or another truss fabricator in the area that has the special frame truss hauling trucks.

Hanger Nails Above The Neutral Axis

Question: 

I recall seeing a design recommendation several years ago regarding installation of hanger nails above the neutral axis of the bottom chord of a plated girder truss. The intent was to avoid dumping large loads into the bottom chord, below the neutral axis. Can you tell me where I can find this information?

Design Loads Vs Typical Loading Conditions

Question: 

The Corps' guide spec for wood construction requires the drawings to indicate the design forces on each truss member for the worst loading condition. Loading conditions, of course, can include wind, snow build up, and unbalanced loading, to name a few. Many A/E firms submit drawings lacking these member forces, but instead show typical loading conditions. What does the wood truss fabricator want to see – truss diagrams with maximum loads on each member? Or would he prefer to design the truss from many required loading diagrams?

Duct Chase Sizes

Question: 

Are there charts illustrating allowable HVAC duct sizes that can fit between truss chords for various truss depths?

Treated Lumber In Wood Trusses

Question: 

Can one use pressure-treated lumber in metal plate connected truss construction? If so, are special plates or coatings required?

Changes In Roof Pitch

Question: 

We are changing plans from a two story home to a one story home. The original roof pitch is 12/12 with three dormer windows, one large one in the center and a smaller one on either side. Can you tell us what pitch would be advisable under this new plan still using the dormers?

Construction Loads On Floor Truss Assemblies

Question: 

How much OSB can be stacked on a floor deck without damaging the trusses?

Determining Earthquake Loads

Question: 

We are currently developing a project which specifies “Seismic Design Category C.” We are an East Coast truss manufacturer and have not encountered seismic requirements before.

Scissors Truss Diagonal Bracing

Question: 

We are finding it difficult to design permanent diagonal bracing for scissors trusses. The truss is often only a few feet in depth, which does not provide adequate room for diagonal bracing. Has SBCA come up with recommendations for permanent bracing of scissors trusses?