Product Performance

Ramp It Up!

Trusses provide a cost-effective, responsive solution to concrete formwork.

This Isn’t Your Father’s Truss Bridge

An unusual design project gives this CM international exposure.

Rock the Block

CM increases profit with pre-designed shear blocking panels.

Inside the Box Building

Innovative thinking and careful construction allowed Truss Craft to give a condemned structure new life.

Temporary Bracing Documents

Question: 

Is it common practice for the supplier/distributor of a truss to provide a publication regarding temporary bracing with the delivery of the material?

Additional Loads

Question: 

I am a structural engineer designing pool cage structures that are typically attached to the house at the fascia board. Sometimes, the structure is attached where trusses are behind the fascia board and other times there is a framed gable end overhang. Do you know of any information concerning this additional load on the trusses or overhang under design wind loads? Is there a limiting distance on the amount of overhang? I know trusses are designed for certain uplift and the pool cage will add to this uplift at design load, but what about the gable end overhangs?

Attachment Of Scissors Trusses

Question: 

What is the correct method of attaching scissors trusses to the top plate? I read recently in a trade magazine that this type of truss should be toe-nailed on one end and attached with slotted clips on the other end. According to the article, this is to allow for movement of the truss. We require PE stamped spec sheets from the truss manufacturer to verify trusses meet wind and snow loads. These sheets give bracing requirements but never give recommended attachment requirements.

Standard On Center Spacing

Question: 

What is the recommended standard spacing for open-web wood joists? I have seen them placed 24 in. O.C. Is this acceptable for a customer who will have an exercise room with 500 pounds of free weights? I understand there are problems with bouncy floors with 24 in. spacing. Is this true?

Roof Truss Nailing With Hurricane Clips

Question: 

If you use hurricane clips to secure roof trusses from uplift, are you allowed to use fewer than the typical three nails in the bearing heel of the roof truss? I am concerned because we want to do the right fastening schedule, but three nails in addition to the hurricane clip splits the wood. What is the standard recommendation?

Partition Separation

Question: 

I installed roof trusses in my house and dry walled the ceiling to the bottom of the trusses. Now I seem to have a problem with the change of the seasons. Where the ceiling meets the interior wall, a gap opens and closes – in winter it opens, in summer it closes. What did I do wrong, how can I correct it and how should the drywall be installed in the first place?